Weider Pro 235 831.150300 User Manual page 7

2. Press a 25mm Round Inner Cap (33) into the
tube on the Right Upright (7).
Lift the Weight Rest (9) in the Right Upright (7)
and secure it in a raised position with a Weight
Rest Knob (23).
Attach the Right Upright (7) to the right Crossbar
Extension (5) with four M10 x 78mm Bolts (38),
two Joint Plates (18), and four M10 Nylon
Locknuts (48). Do not tighten the Locknuts yet.
Repeat this step with the Left Upright (not
shown).
3. Press three 45mm Square Inner Caps (26) into
the Front Leg (2).
Attach the Front Leg (2) to the Bench Frame (1)
with two M10 x 65mm Bolts (35), two M10
Washers (46), and two M10 Nylon Locknuts (48).
Do not tighten the Locknuts yet.
4. Attach the Bench Frame (1) to the center holes in
the Crossbar (4) with two M10 x 72mm Bolts (43)
and two M10 Nylon Locknuts (48).
Tighten the M10 Nylon Locknuts (48) used in
steps 1–4.
2
9
23
7
18
38
38
3
26
2
46
48
26
4
43
1
43
7
33
48
18
48
5
35
1
46
35
26
Center
4
Holes
48