Weider 831.159820 User Manual page 13

25. Route the Leg Press Cable (95) through the Left
Leg (36) and the Left Upright (7) as shown. Wrap
the Cable around a 3 1/2" Pulley (38). Attach the
Pulley inside the Upright with a 3/8" x 2 3/4" Bolt
(81), two 3/8" Washers (75), two 1/2" Spacers
(34), and a 3/8" Nylon Locknut (70).
26. Wrap the Leg Press Cable (95) around a 3 1/2"
Pulley (38). Attach the Pulley inside the bracket
on the Left Top Frame (3) with a 3/8" x 2" Bolt
(62) and a 3/8" Nylon Locknut (70).
27. Remove the preattached 3 1/2" Pulley (not
shown) from the "U"-Bracket (85).
Attach the end of the Leg Press Cable (95) to the
"U"-Bracket (85) with a 1/4" Washer (35) and a
1/4" Nylon Locknut (65). Note: Do not complete-
ly tighten the Locknut; it should be threaded
only two turns onto the end of the Cable, as
shown in the inset drawing.
28. Locate the Butterfly Cable (46). Attach the
Cable to the Pivot Bracket (48) on the Left
Butterfly Arm (10) with an 5/16" x 1" Shoulder Bolt
(78) and a 5/16" Nylon Locknut (71).
25
75
81
26
27
95
35
65
85
28
13
38
34
70
75
34
7
95
36
3
70
62
38
95
95
65
71
46
78
48
10