Maintenance; Recommended Maintenance Schedule(S); Cleaning The Bagger And Bags; Inspecting The Bagger Belt - Toro Grandstand 78524 Operator's Manual

Maintenance

CAUTION
If you leave the key in the switch, someone could accidently start the engine and seriously
injure you or other bystanders.
Remove the key from the switch before you perform any maintenance.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 8 hours
After each use
Every 25 hours
Every 100 hours
Cleaning the Bagger and
Bags
Service Interval: After each use
Note:
If you do not clean the bagger, dried grass can
accumulate and clog the blower housing and tube.
1. Wash the inside and outside of the bagger
hood, bags, tube, fill-indicator impeller, and
the underside of the machine. Use a mild
automotive detergent to remove dirt.
2. Make sure that you remove matted grass from
all parts.
3. After washing all parts, let them dry thoroughly.
Note:
With all parts installed, start and run the
machine for a minute to assist in drying.

Inspecting the Bagger Belt

Service Interval: After the first 8 hours
Every 25 hours
Check belts for cracks, frayed edges, burn marks, or
any other damage. Replace damaged belts.

Replacing the Bagger Belt

1. Disengage the PTO, move the motion-control
levers to the N
EUTRAL
engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
Maintenance Procedure
• Inspect the bagger belt.
• Inspect the bagger.
• Clean the bagger, bags, and fill-indicator impeller.
• Inspect the bagger belt.
• Inspect the impeller assembly.
• Inspect the bagger.
- position, and
LOCK
3. Lower the mower deck to the lowest setting.
4. Loosen the knob on the belt cover and remove
the cover.
5. Open the blower assembly to access the belt
and pulley.
6. Pull back on the spring-loaded idler pulley to
relieve the belt tension
1. Belt
7. Remove the existing bagger belt from the deck
and blower assembly by rotating the blower
pulley as you pull the belt off.
8. Install the belt around the blower and idler
pulleys as shown in
19
(Figure 26).
Figure 26
2. Spring-loaded idler pulley
Figure 27. Place the belt
g256119