Before You Begin - Razor Pocket Mod Petite Owner's Manual

BEFORE YOU BEGIN

Remove contents from box. Remove the separators that protect the components from damage during shipping. Inspect
the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during shipping.
Because the Pocket Mod Petite is 95 percent assembled and packed at the factory, there should not be any problems,
even if the box has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED "OFF" BEFORE CONDUCTING ANY
MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult.
Allow up to 15 minutes for assembly.
Allow up to 12 hours for initial charge (see page 7 for charging information).
Charger
Note: Charger design may
vary from one shown
Throttle
On/Off Switch
Charger Port
Hub Motor
Required Tools
3 mm Allen Wrench,
5 mm Allen Wrench and
6 mm Allen Wrench (included)
2.
Brake Lever
3.
1.
Two (2) 14 mm/17 mm
Wrenches (included)
Center Stand
Phillips Screwdriver (included)
3
WARNING: DO NOT USE
NON-RAZOR PRODUCTS WITH
YOUR RAZOR POCKET MOD
PETITE. The Pocket Mod Petite
has been built to certain Razor
design specifications. The original
equipment supplied at the time of
sale was selected on the basis of
its compatibility with the frame,
fork and all other parts. Certain
aftermarket products may not be
compatible and will void
your warranty.
Product ID Locations:
(See locations to the left)
1. Underneath Frame
2. Charger
3. Underneath Charger Port
4. UPC Side of Box (not shown)
Plastic Bag Contents:
• Charger
• Tools
• Owner's Manual