Assembly And Set-Up - Razor Pocket Mod Petite Owner's Manual

ASSEMBLY AND SET-UP

Turn power switch off before conducting any maintenance procedures.
Attaching the Handlebars
Tool Required: 6 mm Allen Wrench
Steering Bolt
1
Using a 6 mm Allen wrench, loosen steering bolt in four (4) complete turns
so that the wedge is loose and not touching steering tube.
3a
While inserting the steering
tube down into the handlebar tube,
hold steering bolt steady with thumb
and rotate handlebars 180 degrees
in either direction making sure not to
pinch any cables.
Steering Bolt
5
Securely tighten bolt using 6 mm
Allen wrench.
Need Help? Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer
Service contact information is listed at the back of this manual.
Wedge
3b
The throttle should now be
on your left and the brake lever on
your right.
2
Facing the front of the Pocket Mod
Petite, position the handlebars so the
throttle is on your right and the brake
lever is on your left (the red "SAFE
ZONE" print will be facing you). Align
wedge inside handlebar tube. Note:
Plastic cover needs to be removed
prior to installing the handlebars.
Safe Zone
4
Slowly slide the handlebars up
to make certain that the bar is in the
"SAFE ZONE". Failure to secure the
handlebars within the "SAFE ZONE"
can cause the handlebars to come
out while riding.
4
Note: Make sure the brake cables/
wires are out of the way before
inserting the handlebar into the fork.
WARNING: Periodically
check to make sure the steering bolt
is tightly fastened.
Note: Failure to secure the
handlebars within the "SAFE ZONE"
can cause the handlebars to come
out while riding.