ButterBall 23014314 Operation Manual & Safety Instructions page 6

PROGRAMMED COOKING: SETUP AND USAGE
To power up, plug unit into power source. Initially the power indicator will illuminate red and the digital
readout will blink 375° F, indicating the unit is in standby mode.
Temperature Mode Select
Step 1
Select desired cooking mode by pressing the temperature button
push +/- buttons to scroll through mode options of OFF/BOIL/300°F/325°F
/350°F or 375°F.
Step 2
Press temperature button again to set mode.
*Note: The mode function can be changed at any time by pressing the
temperature button.
Temperature Mode Functions
OFF: The display will blink OFF 5 times, after which time the unit will power
down. Please allow adequate time for liquids to cool as the temperature will
not immediately drop once the unit has powered down.
BOIL: (Use only water in boil mode) In this mode, the indicator will read BOIL.
Slowly lower food once water comes to a boil. The ready light will not illumi-
nate during boil operation.
*Note: Water will not instantaneously begin to boil and must still
have time to reach desired temperature.
300°F/325°F/350°F/375°F: Once desired frying temperature is indicated,
simply press temperature button to select cooking temp. In fry mode the letter
"H" will blink during pre-heat while the element cycles on and will cease to
blink once temp has been reached. There is no pre-heat "H" indicator when
boiling. The green ready indicator will illuminate when oil reaches the set
temp.
*Note: Oil will not instantaneously reach desired temperature.
Please allow time for pre-heat.
Timer Programming
Step 1
Program the timer by pressing the timer button. Timer will flash. Select time from 00 – 99 minutes by pressing the +/–
buttons in 1 minute increments, or hold down the +/– button to change time in 10 minute increments.
*Note: If no time is selected within 5 seconds, the timer will set to the previous programmed time
Step 2
Once the desired time is indicated on the digital screen, press the time button again to set. The timer will stop flashing
indicating the time has been set. The timer can be changed during any portion of the cooking process by simply pressing
time button and repeating steps 1 and 2 to set.
The timer will sound out 10 long beeps when time is up.
*Note: Cooking times and temperatures may vary due to altitudes.
NOTE: In the event that the cord becomes disconnected during cooking, the fryer will maintain the last
set time and temperature for up to 2 minutes. However, some heat loss could occur during the
time that the fryer is disconnected from power source.
5
and
UP
DOWN
TEMPERATURE
TIMER
READY
POWER