Table of Contents
Advertisement
Input board slots
— Install input boards or blank plates in the available slots in any
A
order or arrangement. Note the input numbers associated with each slot. The boards
align vertically except on the XTP II CrossPoint 1600 where they align horizontally.
Ensure a board or blank plate is installed in every slot.
Output board slots
— Install output boards or blank plates in the available slots in any
B
order or arrangement. Note the output numbers associated with each slot. The boards
align vertically except on the XTP II CrossPoint 1600 where they align horizontally.
Ensure a board or blank plate is installed in every slot.
Remote RS-232 and RS-422 connector
C
connector for serial RS-232 or RS-422 control of the matrix switcher (see
RS-232 and RS-422 Connection
NOTE: The matrix switcher supports the RS-232 or RS-422 serial communication
protocol, and operates at 9600, 19200, 38400, or 115200 baud rates.
To connect an MKP 2000 or MKP 3000 remote control panel, see to the MKP 2000
Remote Control Panel User Guide or the MKP 3000 User Guide for details.
Ethernet LAN connector
D
control the matrix switcher remotely through Ethernet. Use a patch cable to connect to
a switch, hub, or router. The LAN connector includes the following LED indicators:
Activity LED indicator — Blinks when the matrix switcher communicates with the
•
connected device.
Link LED indicator — Lights when the matrix switcher is connected to an
•
Ethernet LAN.
Reset button and LED
E
(see
Reset Modes
on page 41).
Power connector
— Connect a power supply to the AC power connector.
F
Default AC power — Connect a 100 VAC to 240 VAC, 50-60 Hz
•
power source to this connector with a standard IEC power cord to
this connector.
Attached AC power (XTP II CrossPoint 6400 only) —
•
North America — Connect the power cord into a NEMA L6-20
•
220 VAC, 60 Hz power outlet.
Other regions — Have a licensed electrician install a 200-240 VAC power
•
connector. Then, connect the power cord into a 200-240 VAC,
50-60 Hz power outlet. Ensure the wiring is in accordance with electrical codes.
ATTENTION:
•
The outlet or junction box must be installed near the equipment and be
easily accessible.
•
La prise de courant ou la boîte de jonction doivent être installées près
du dispositif et être facilement accessibles.
•
The installation location must provide short circuit and overcurrent
protection, to a minimum of 20 A.
•
Le lieu d'installation doit disposer d'une protection contre les courts-
circuits et la surtension de 20 A minimum.
•
Do NOT use an extension cord.
•
Ne PAS utiliser de rallonge électrique.
— Connect a host device to the 9-pin D
on page 19 for wiring details).
— Connect a computer network to the RJ-45 connector to
— Press the
button to activate different reset modes
Reset
XTP II CrossPoint Series • Installation
Remote
L6-20R
North America
X
G
Y
X: Hot Y: Hot
G: Ground
12
Advertisement
Table of Contents
