Feet Assembly - Zanussi ZCM 700 Instruction Booklet

Feet Assembly

Before installing the cooker, it is necessary to assemble
the supplied feet. You can find them in the oven cavity.
"
1. Remove the hob pan supports, the burner
caps and crowns.
2. Carefully lean the cooker on its back (Fig.
1), paying attention not to cause any
damage.
3. Adjust the feet height. A height indicator is
printed on the last page of this Instruction
book (Fig. 2). Lean the foot on the page
and make the foot match with the indicator,
then unscrew the bottom part of the foot,
until you obtain the required height. Repeat
the same operation with the other feet.
4. Screw the feet into the relevant holes
indicated in figure 1.
5. Lift the cooker in vertical position. Replace
the crowns, the burner caps and the hob
pan supports.
6. Ensure that the cooker is level. If necessary,
adjust by turning the bottom part of the feet,
until the appliance is completely stable.
(Fig. 3). A spirit level should be placed on a
cake tray on one of the shelves to confirm
that the appliance is correctly levelled.
24
FO 2283
Fig. 1
FO 2284
Fig. 2
FO 2285
Fig. 3