Replacing The Heating Elements In The Handles - Husqvarna 545RXT AT Workshop Manual

5.8 Replacing the heating elements in
the handles
The heating elements in the handles consist of ceramic
plates that self-regulate the temperature. When the
temperature increases, the resistance in the elements
increases and the temperature lowers. No separate
thermostat is needed.
1. Remove the throttle from the handle. See "5.4
Dismantling the throttle (finger)" on page 14
2. To remove the heating element, remove the bolt (A)
that holds the throttle and cover (B). See figure 1.
3. Remove the 2 bolts to the heater switch.
One heating element is placed in the throttle lock out.
4. Press the locking catch from the throttle. Make sure
not to lose the spring (A).
5. Pry off the locking catch (B) and lift out the heating
element (C). See figure 2.
CAUTION: Do not pry off the heating
element before the locking catch has been
removed. The element can get damaged.
18 – English
Fig. 1
Fig. 2