Troubleshooting - Weber Electric Grill Q 140 Owner's Manual

10
This appliance is Rated for
120 volts - 50/60Hz, 13 Amps
Output: 1560W
COOKING
WARNING: Completely unwind power
cord. Keep cord clear of cookbox.
1) Plug Temperature Controller into grill.
Always plug Temperature Controller
fully into grill before plugging power
cord into outlet. (See page 7, Step C)
2) Open Lid.
3) Make sure the Temperature Controller is turned
OFF. (Turn control knob counterclockwise to
ensure that it is in the OFF position.)
2).
6).
1).
Problem
Electric grill does not turn on.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your
region using the contact information on our web site. Log onto www.weber.com
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS
4) Plug in power cord into a protected outlet.
The appliance should be supplied
through a grounded GFI outlet, 15
amp minimum.
5) Preheat the grill. Turn control knob to HIGH
(clockwise). The red light indicates that power is
on and the heating element is heating up.
6) Close lid. Preheat time will take approximately
15 minutes (when grilling in a 72˚F air
temperature). Colder temperatures and/or wind
can cause longer preheating times.
3).
5).
4).

TROUBLESHOOTING

Check
Is the Temperature Controller properly inserted into
housing?
Is red power light on and temperature control knob fully
turned clockwise to HIGH?
Is power available from outlet?
To cook at a lower grill temperature: Preheat
as previously stated. Turn the control knob
counterclockwise to desired setting. Start cooking.
Reference the cooking charts at end of Owner's Guide
for approximate grilling times and settings for the cuts
of meats listed. (adjust for conditions).
WARNING: When red light is off,
heating element may still be hot.
A. - OFF
A
B. - LOW
B
C. - MED.
C
D. - HIGH
D
Cure
Remove and reinstall Temperature Controller.
Always plug Temperature Controller fully
into grill before plugging power cord into
outlet. (See page 7, Step C)
Remove and reinstall Temperature Controller.
Always plug Temperature Controller fully
into grill before plugging power cord into
outlet. (See page 7, Step C)
Check electrical service.
Check if GFI is tripped.
®
.