Sear Station ® Troubleshooting; Rotisserie Troubleshooting; Grill Out™ Handle Light Troubleshooting - Weber Summit 56209 Owner's Manual

PRobLEm
burners burn with a yellow or
orange flame, in conjunction with
the smell of gas (this is normal for
the burner lighting tube).
sear station burner does not light.
®
if problems cannot be corrected by using these methods, please contact the Customer service representative in your area using the contact information on our
web site. Log onto www.weber.com
PRobLEm
rotisserie burner does not light.
if problems cannot be corrected by using these methods, please contact the Customer service representative in your area using the contact information on our
web site. Log onto www.weber.com
PRobLEm
weber Grill out™ handle Light
does not light.
if problems cannot be corrected by using these methods, please contact the Customer service representative in your area using the contact information on our
web site. Log onto www.weber.com
SEAR STATIoN
cHEcK
Inspect Spider/Insect Screens for possible obstructions . (Blockage
of holes .)
Did you ignite the two adjacent main burners? (Refer to "SEAR
STATION IGNITION & USAGE" instructions for safe lighting
®
procedure)
Does Burner light with a match?
Does the igniter work (Do you see a spark when you repeatedly
use the snap igniter?)
.
®

RoTISSERIE TRoUbLESHooTING

cHEcK
Did you hold the burner control knob in and hold in for 20 seconds
until after burner ignited?
Did you wait to see the entire ceramic surface become alight
before counting 20 seconds?
Did you repeatedly use the snap ignition until the burner ignited?
Does the igniter work? (Do you see a spark when you repeatedly
use the snap igniter?)
.
®
GRILL oUT™ HANDLE LIGHT TRoUbLESHooTING
cHEcK
Are the batteries old?
Are the batteries installed correctly?
Is the lid in the up position with the power button ON?
Is the Weber Grill Out™ Handle Light activated?
Is the Weber Grill Out™ Handle Light positioned correctly on the
handle?
.
®
TRoUbLESHooTING
®
Clean Spider/Insect Screens (refer to "ANNUAL MAINTENANCE") .
Verify adjacent main burner ignition by visual inspection of a flame .
m wArninG: if ignition does not occur in five
seconds, turn burner control off, wait five
minutes to let the gas clear before you try
again
If you can light Burner with a match, then check the Crossover
Channel on the sear burner (refer to "MAINTENANCE" for burner
removal and cleaning procedure) .
Try manually lighting the burner (refer to "SEAR STATION
IGNITION & USAGE") . Call customer service .
Try to relight burner by holding burner control knob in and continue
holding in until 20 seconds after burner has ignited .
When relighting burner by holding burner control knob in, wait to
see the entire ceramic surface become alight before counting 20
seconds?
After waiting five minutes for gas to clear, try repeatedly using
the snap igniter until the burner ignites (refer to "ROTISSERIE
BURNER IGNITION & USAGE") .
Try manually lighting the burner (refer to "ROTISSERIE BURNER
MANUAL IGNITION") . Call customer service .
Replace batteries .
Refer to assembly illustration .
Light will activate when lid is open .
Press the power button .
Adjust position (refer to assembly illustration) .
SoLUTIoN
®
®
SoLUTIoN
SoLUTIoN
WWW.WEbER.com
® 31