Main Burner Flame Pattern; Main Burner Cleaning Procedure; Replacing The Main Burners - Weber SUMMIT 425 Operating Manual

MAINTENANCE
Main Burner Flame Pattern
The Weber Gas Barbecue burners have been factory set
for the correct air and gas mixture. The correct flame
pattern is shown in Figure 7.
Tips occasionally yellowish
Burner inside
cooking box
j,__" Light blue
" Dark blue
Flames
Figure 7
If the flames do not appear to be uniform the length of the
burner tube, follow the burner cleaning procedures.
Replacing Main Burners
1. Your Weber Gas Barbecue must be OFF and cool.
2. Turn OFF gas at source.
3. Disconnect regulator.
4. To remove control panel refer to "Remove the control
panel and the front panel" in the Step-By-Step Guide.
5. Remove cooking grates.
6. Remove Flavorizer bars.
7. Remove the manifold by unsnapping the clips at the
right and left front of the cooking box. Figure 10.
Main Burner Cleaning Procedure
Turn off the gas supply. Remove the manifold.
Look inside each burner with a flashlight. Figure 8.
f
Clean the inside of the burners with a wire (a straightened
out coat hanger will work). Figure 9. Check and clean the
air shutter opening at the ends of the burners. Check and
clean the valve orifices at the base of the valves. Use a
brass bristle brush to clean outside of burners. This is to
make sure all the burner ports are fully open.
/
Figure 9
CAUTION: Do not enlarge the burner ports when cleaning.
.
Figure 10
Disconnect white and black wire from each igniter.
Figure 11.
White wire,
Black wire
Figure 11
11