Control Knobs - Weber SKYLINE SKYLINE 520 Owner's Manual

Step 16
Install Lid
You will need: lid, two hinge pins and two hair pin cotters.
Set the lid in place. Align the hinges at the rear of the
barbecue. Insert hinge pins from the outside. Insert hair pin
cotters into the small holes in the hinge pins. Figure 21.
Figure 21
Hair pin cotter
Hinge pin
Step 17
Add tool holders, control panel and burner

control knobs

You will need: two tool holders, control panel, two Phillips
screws/washers, a Phillips screwdriver, and two burner
control knobs.
Hook the tool holders over the frame rail. Figure 22.
Set the control panel in place over both frame braces.
(Hold the Crossover Ignition button up while setting the
control panel in place.) Line up the holes in the control
panel with the holes in the inserts in the frame brace.
Insert screws and tighten with a Phillips screwdriver until
snug. Do not overtighten. Figure 22 (a).
Push on the burner control knobs. Figure 22 (b).
Crossover
Ignition
Button
Tool holders
17
frame brace
(a)
Control panel
Phillips screws/
washers
(b)
Figure 22
Insert in