Festool Impact TI 15 Original Operating Manual page 16

TI 15
GB

Turn the clamping ring as far as the stop to se-
cure the adapter.
Angle attachment DD-AS [7]
Drilling and screwing at right angle to machine
(partly as an accessory).
Eccentric attachment DD-ES [8]
Screwdriving near edges with bits according to ISO
1173 (partly as accessory).
9 Working with the machine
9.1 Operating modes
Depending on the tool holder / adapter selected,
the machine is operated as follows:
Screwing with impact
– WH-CE CENTROTEC tool chuck (see
Chapter CENTROTEC tool chuck [4])
Screwing and drilling without impact
– TI-FX adapter (see Chapter TI-FX adapter
[6])
• DD-AS elbow adapter
• DD-ES eccentric attachment
• DD-DC screwdriver attachment
– BF-TI 13 chuck (see Chapter BF-TI 13
chuck [5])
9.2 On/Off switch [1-2]
WARNING
Risk of injury

Only place the machine on the nut/screw when
switched off.
Press = ON, release = OFF
 Depending on the pressure applied to the ON/
OFF switch the speed/impact rate can be con-
trolled continuously.
The LED bulb [1-4] lights up when the ON/OFF
switch is pressed [1-2].
9.3 Bit depot [1-1]
Magnetic, for storing bits and bit holders.
9.4 Belt clip [1-9]
For short-term fixing of the device to work attire:
can be moved to the right or left or can also be de-
tached from the battery pack.
9.5 Acoustic warning signals
Acoustic warning signals sound and the machine
switches off in the following operating states:
16
Battery flat or machine over-
loaded.
– Change the battery.
– Place the machine under reduced
stress.
Machine is overheating.
– You must allow the machine to
cool before using again.
LiIon battery pack is faulty or has
overheated.
– Once the battery pack has cooled,
perform a functional check using
the charger.
10 Service and maintenance
WARNING
Risk of injury, electric shock

Always disconnect the battery pack from the
machine before any maintenance or care work!

All maintenance and repair work which requires
the motor housing to be opened, must only be
carried out by an authorised service workshop.
Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at:
www.festool.com/Service
EKAT
Use only original Festool spare parts!
4
Order No. at:
5
www.festool.com/Service
3
2
1
Note the following information:
– Keep the ventilation slits on the machine free and
clean to ensure adequate cooling.
– Keep the contacts on the machine, charger and
battery pack clean.
Information on battery packs
– Store in a cool, dry place at a temperature be-
tween 5 °C and 25 °C.
– Protect battery packs from moisture, water and
heat.
– Do not leave flat battery packs in a charger dis-
connected from the mains power supply for lon-
ger than one month. Danger of deep discharge!
– If you intend to store li-ion battery packs for lon-
ger periods without use, you should charge them
to 40 % capacity (approx. 15 min charging time).