Installing Work Surfaces & Gas Connection Guidelines - Weber Genesis Gold B Owner's Manual

Installing Work Surfaces &
Gas Connection Guidelines
Install Left Work Surface
You will need left work surface, two 1/2 inch bolts, two
nylon washers and a 7/16 inch or adjustable wrench.
Insert the left work surface tabs in the slots in the
frame(1). Slip washers on the bolts and insert the bolts
as shown(2). Tighten
(1)
C017.a
(2)
Check that all burner valves are off
You will need: burner control knobs.
Valves are shipped in the OFF position, but you should
check to be sure that they are turned OFF. Put the
knob on each valve. Check by pushing down and
turning clockwise. If they do not turn, they are off.
Proceed to the next step. If they do turn continue
turning them clockwise until they stop, then they are
off. Proceed to the next step.
Remove the control panel
(1) Unscrew the two phillips screws, located on the
right edge of the control panel.
(2) Take off the burner control knobs.
(3) Lift off the control panel.
C-1
(2)
(1)