Installing Work Surfaces And Gas Connection Guidelines - Weber 55062 Owner's Manual

Installing Work Surfaces &
Gas Connection Guidelines
Install Left Work Surface
You will need left work surface, two 1/2 inch bolts, two
nylon washers and a 7/16 inch or adjustable wrench.
Insert the left work surface tabs in the slots in the
frame(1). Slip washers on the bolts and insert the bolts
as shown(2). Tighten
(1)
C049.a
(2)
Check that all burner valves are off
You will need: burner control knobs.
Valves are shipped in the OFF position, but you should
check to be sure that they are turned OFF. Put the
knob on each valve. Check by pushing down and
turning clockwise. If they do not turn, they are off.
Proceed to the next step. If they do turn continue
turning them clockwise until they stop, then they are
off. Proceed to the next step.
Install Side Burner Assembly
You will need side burner assembly (assembly
includes mounting frame), two 1/2 inch bolts, two nylon
washers and a 7/16 inch or adjustable wrench.
Note: Remove protective covers from tabs of side
burner
Insert the side burner tabs in the slots of the frame(1).
Slip washers on the bolts and insert the bolts as
shown(2). Tighten bolts with wrench.
(1)
C-1
(2)