Weber 700 Series Owner's Manual page 19

Step 19
Install Swing Table
You will need: swing table assembly, support rod, support
rod holder and swing table end bracket.
Insert the ends of the support rod through the lower keyholes
in the swing table. Figure 24 (a). Slide until the tabs on the
support rod pass through the keyholes. Figure 24 (b). To
keep the support rod in place, rotate the rod so the tab is
not lined up with the keyhole. Figure 24 (c).
Lower keyhole
(a)
(c)
(b)
Support rod
Figure 24
Insert one end of the hinge rod into the hole in the frame.
Figure 25 (a).
Insert the other end into the hole in the swing table end
bracket. Figure 25 (b). Hold the end bracket at an angle so
the lower tab is inside the frame tube. Push the bracket into
the frame. Check to see that the lower tab of the bracket is
hooked in the slot in the frame. Figure 25 (c).
To fully seat the bracket, you may have to tap it lightly with a
hammer.
WARNING: If swing table end bracket is in any way
cracked or damaged, do not use swing table. Call our
Customer Service Center to order a new part.
Install support rod holder on leg. Figure 25 (d). Hook the
support rod into the support rod holder.
WARNING: The load limit for the swing table is
30 pounds.
Hinge rod
(a)
View from rear
of barbecue
(d)
19
(b)
Slot in frame
(view from below)
(c)
Figure 25