Weber 5000 Series Owner's Manual page 40

d) Unlatch the Spider Stopper Guards and remove.
Figure 16.
Figure 16
e) Use an adjustable wrench to remove the
thermocouple from the FlameCheck valve.
f) Remove the manifold bracket and unscrew the two
wing nuts that hold the manifold to the cooking
box. Pull the manifold and valve assembly out of the
burners and carefully set it down. Figure 17.
Figure 17
g) Slide the burner assembly out from under the guide
screw and washer in the corners of the cooking box.
Figure 18.
Guide screw
Figure 18
View from behind
cooking box
Wing nuts
40 40
h) Lift and twist the burner assembly slightly, to
separate the crossover tube from the burners.
Figure 19. Remove the burners from the cooking
box.
Crossover tube
Figure 19
i) To reinstall burners, reverse steps c) through h).
CAUTION: The burner openings must be
positioned properly over the valve orifices.
Figure 20a.
Check proper assembly before fastening manifold in
place. Figure 20b.
(a)
Valve
Burner
(b)
Figure 20