Weber 5000 Series Owner's Manual page 20

Position slide bar assembly on the outside of the caster
frame. Put a nylon washer on each 1 3/4 inch screw,
insert screws through frame and slide bar assembly and
add nylon washers and hex nuts. Tighten nuts using a
screwdriver and pliers. Figure 25.
Notch to the front
Slide bar
Figure 25
To lower table: Pull support rod up to disengage slide
lock, and lower table. To raise table, lift table up and
engage slide in locked position. Figure 26.
Unlocked position
Figure 26
View from front
of barbecue
Support rod
View from rear
of barbecue
Slide
Locked position
Step 21
Install right hand swing table
You will need: swing table end bracket, two 10-24 hex
nuts, two 10-24 x 1 3/4 inch machine screws, right
hand slide bar assembly, swing table, four nylon
washers, screwdriver and pliers.
Allow the slide bar to hang down. Push the support rod
into the lower support bracket. Figure 27 (a). Swing the
rod up so you can slide the rod all the way inside the
locking tab. Figure 27 (b). The rod should swing freely
inside the locking tab. Figure 27 (c).
(b)
20
View from rear
Support rod
(a)
Slide bar
assembly
Figure 27
(c)