Table of Contents
Advertisement
Configuring the Firebox for
CHAPTER 18
Remote User VPN
Remote user virtual private networking (RUVPN) establishes a secure connection
between an unsecured remote host and a protected network over an unsecured
network. RUVPN connects an employee on the road or working from home to trusted
and optional networks behind a Firebox using a standard Internet dial-up connection
without compromising security.
WatchGuard Firebox System offers two types of RUVPN:
Remote User PPTP
Uses the Point-to-Point Tunneling Protocol. This type of RUVPN is included
with the basic WatchGuard package and supports up to 50 concurrent
sessions per Firebox. Works with any Firebox encryption level.
Mobile User VPN
Uses Internet Protocol Security. This type of RUVPN is an optional feature of
the WatchGuard package. It requires strong or medium encryption.
RUVPN requires configuration of both the Firebox and the end-user remote host
computers. This section describes how to configure a Firebox for both types of
RUVPN. For information on configuring the remote host, see "Preparing a Host for
Remote User VPN" on page 141.
Remote User PPTP and Mobile User VPN require that the Management
Station be upgraded to either medium or strong encryption level. The medium
and strong encryption upgrade files are available to eligible users on the
LiveSecurity Service Web site at http://www.watchguard.com/support.
Configuration checklist
Before configuring a Firebox to use remote user virtual private networking (RUVPN),
gather the following information:
• The IP addresses to assign to the remote client during RUVPN sessions. The IP
addresses cannot be addresses currently in use in the network.
User Guide
133
Advertisement
Table of Contents
