Breville Mistic 2 in 1 Connect LTF408 Instruction Book page 18

CARE AND CLEANING
When switching off the tower fan, the front
pivot grille cover will rotate automatically
to protect the air outlet grille. This will
help to keep the air outlet grille clean. Wait
until the front pivot grille cover is fully
closed before switching off at the power
outlet. Unplug from the power outlet prior
to cleaning the base, grilles, housing, water
container and water inlet basin.
CLEANING EXTERNAL PARTS
To clean the outside of the tower fan, wipe
the exterior with a soft, damp cloth. Never
use an abrasive cleaner.
Ensure all parts of the tower fan are clean
and dry before storing.
CLEANING THE HUMIDIFIER
INTERNAL PARTS
WATER CONTAINER, WATER
CONTAINER CAP & SEAL
• Remove the water container and unscrew
the water container cap with seal.
• It is important to clean the water
container regularly and ensure it is
dry before reassembling and using the
humidifier function.
• To clean, create a vinegar and water solution
of 1-part vinegar to 1-part water, enough to fill
the container about halfway.
• Making sure the water container cap is
replaced on the container, swish the solution
around for a minute, then fill the rest of the
container up with tap water. Leave to sit for
1–2 hours, or even overnight.
• Empty and rinse well with clean water.
18
LTF408_ANZ_IB_D20.indd 18 LTF408_ANZ_IB_D20.indd 18
WATER INLET BASIN
Build-up of calcification may occur in the
water inlet basin and should be removed and
cleaned to ensure optimum performance.
Remove the water container to clean the
water inlet basin.
• Ensure the water outlet cap remains in place.
If build-up of calcification is present in the
water inlet basin, rinse with a vinegar and
water solution and let soak for 10 minutes.
Remove the water outlet cap and drain the
vinegar water into a drain source. Replace
the water outlet cap. Rinse with clean water
and drain once more.
• With a damp cloth, wipe the tube, mist cover
and water inlet basin (Fig. 3).
• If there is calcification on the surface, soak
a clean cloth with 1:1 parts vinegar and
water solution and repeat the process until
removed. Wipe with a clean, damp cloth.
Fig 3
Ensure all parts of the tower fan are dry
before storing.
Tube
Mist Cover
Water inlet
basin
15/7/20 2:14 pm 15/7/20 2:14 pm