Breville Mistic 2 in 1 Connect LTF408 Instruction Book page 16

n
NOTE
Keep the tower fan straight when moving
if there is water in either the water tank or
water inlet basin as water may spill out.
Some water may remain in the basin of the
water inlet basin at the back of the tower
fan, separate to the water container. This
is normal. To drain excess water after use,
position the tower fan above a drainage
source and remove the water outlet cap from
the back of the tower fan. Tilt the tower fan
backwards towards the drainage source.
REMOTE CONTROL
The tower fan comes with a remote control.
This remote control features the same
icons as the control panel on the tower
fan and can be used the same way. The
remote control has two additional controls
not found on the control panel. The two
functions MODE and TIMER can be set
using the remote control only. Refer to the
MODE and TIMER sections of this book for
more details.
To avoid misplacing your remote control,
place the remote control between the
carry handle, and the controls of the tower
fan frame.
16
LTF408_ANZ_IB_D20.indd 16 LTF408_ANZ_IB_D20.indd 16
USING THE REMOTE CONTROL
Your remote control requires 2 x AAA
batteries (NOT INCLUDED).
To insert the batteries, open the battery
compartment at the back of the remote
by forming a good grip of the remote and
pressing then sliding the battery cover
towards the bottom of the remote. The
battery cover should slide off.
Insert the 2 batteries paying attention to the
polarity (+ and -).
Slide the back battery cover back onto the
remote by lining the 2 tabs on the battery
cover with the 2 grooves on the back
of the remote body. Ensure the battery
compartment is correctly secured so
batteries remain in place.
n
NOTE
To use the remote control, it must be
pointed at the LED display screen and used
within five meters of the tower fan.
15/7/20 2:14 pm 15/7/20 2:14 pm