Breville Mistic 2 in 1 Connect LTF408 Instruction Book page 15

AUTO-ON TIMER
Auto-on can only be set when the tower fan
is on standby mode.
Press the button on the remote. The
symbol will begin to flash and "0.5" will
display on the LED display screen. Press the
and buttons on either the control panel or
the remote until the desired number flashes
on the LED display screen.
Press the button again on the remote to
set the auto-on timer. The time will display
on the LED screen and the
will illuminate. The timer will start on the
last selected mode, and the fan will start
automatically once the time has elapsed.
n
NOTE:
If TIMER is pressed on the remote but
no action is taken, the tower fan will exit
TIMER. Press the
to return to TIMER.
The LED display screen will not display the
remaining auto-off time, instead the display
will return to the set fan setting. Press the
button on the remote and the remaining
time will display on the display screen.
To cancel the auto-on time anytime once the
timer is set, touch and hold the
2 seconds and the
illuminate.
n
NOTE
• The auto-on timer can only be set when the
fan is on standby mode.
• The tower fan will turn on once the auto-on
timer has elapsed.
• The tower fan will operate on the last
selected mode.
• To check the pre-set time left on the LED
display screen, press the
the remote.
LTF408_ANZ_IB_D20.indd 15 LTF408_ANZ_IB_D20.indd 15
symbol
button on the remote
button for
symbol will no longer
button on
OSCILLATION
The tower fan has horizontal oscillation.
The oscillation can be set on any MODE,
including humidification mode.
To activate oscillation, touch the
once. The tower fan will move left to
right continuously.
To stop and direct the orientation of your
tower fan during oscillation, touch the
oscillation symbol again when the airflow
has reached your preferred position.
HUMIDIFICATION
The Breville Mistic 2 in 1
Fan & Humidifier comes with the added
benefit of humidification. The humidifier
can be set on any MODE and emits a mist at
the same time that the fan is operating.
To fill the water container before use, press
the water container release button found
on the outside of the water container on the
back of the tower fan and it will disengage
for easy removal. Turn the water container
upside-down and remove the water
container cap. Fill the water container with
fresh water and replace the water container
cap before reassembling the water container
(upright) back into the tower fan.
To activate the humidifier function, touch
the button once. The tower fan will
automatically release mist on low from the mist
nozzle. The symbol will illuminate on the
LED display screen before setting.
To increase the mist output from LOW to
HIGH, touch the button again. To turn
the humidification off, touch the
again, and the mist output will automatically
stop.
Once the water container is empty, or the
water level is too low, the
begin to flash. Refill the water in the water
container and replace the water container
into the tower fan. The
flashing and stay off. Humidification will
need to be re-activated.
button
Connect Tower
TM
button
symbol will
symbol will stop
15
15/7/20 2:14 pm 15/7/20 2:14 pm