Related Manuals for Curtis 1206-HB
Summary of Contents for Curtis 1206-HB
- Page 1 Curtis 1206-HB to 1268 Conversion Installation Instructions 62-EZHB-AO WORK INSTRUCTIONS REV. 02 9/14/2018...
- Page 2 Contents: 500A Curtis controller, adapter harness, walk-away harness, hardware kit. Before you start disconnect the 4 wires attached to the (Positive) + side of the battery. A. Removing the original controller from the cart: 1. Remove the four - 10mm bolts holding the environmental cover over the original controller and remove cover.
- Page 3 B. Mounting the new controller: 1. Using a rag and cleaner, clear any debris from the thermal pad to maximize thermal transfer. 2. Using the original controllers mounting bolts and holes mount the conversion plate to the vehicle heatsink. 3. Using a small scraper or razor blade, spread the three tubes of thermal compound (included) evenly over the new controllers heatsink.
- Page 4 C. Wiring the new controller: 1. Using the three 13mm bolts retained when the original controller was removed, securely fasten the four large diameter wires to the new controller. C from motor and CB+ from solenoid. A1 from motor CB- from battery 2.
- Page 5 6. Insert the 4 pin original wire harness plug into the new controller. 7. Remove the solenoid environmental protection cover. 8. We will be using an open hole on the solenoid cover mounting tab to fasten the walk-away relay and protection fuse. 9.
- Page 6 11. Plug the two wire- four pin walk-away harness connector to the two wire- four pin conversion harness connector then re-install solenoid cover using original hardware. 12. Remove the tow/run switch from the original controllers environmental cover. 13. Re-install the tow/run switch in the new mount provided using the original hardware.