Lcd Monitor Cabling Diagram - Wacom DTF-521 Installation Manual And User's Manual

LCD MONITOR CABLING DIAGRAM

DTF-521, rear view
The OUT port is used to
ANALOG RGB
connect a second VGA device such
as a projector or monitor that mirrors
the pen display. Be sure to fully
install the DTF-521 hardware and
software before connecting a
projection device to the unit. Do not
connect or disconnect any cable
while the DTF-521 or your computer
are turned on.
C
AUTION
Use only the power adapter that came with the DTF-521; use of an improper power adapter
may damage the unit.
Do not connect or disconnect the video or power cables while the DTF-521 or your
computer are turned on – this can damage the display or computer video card.
Make sure that the display refresh rate does not exceed 70 Hz for XGA mode, or 75 Hz
for other modes.
Installation
Page 12
Do not attach the USB data
cable until instructed to do so.
– B –
DC IN
(12V)
ANALOG RGB
ANALOG RGB
– A –
VGA cable
Video card
VGA port
Rear panel of your computer
Power adapter – C –
OUT
IN
To AC outlet