Metra Electronics 99-6540 Installation Instructions

ALL VEHICLES
1
Disconnect the negative battery terminal to prevent an accidental short circuit. Open the glove
box and remove (2) Phillips screws securing the right edge of the dash trim bezel. Remove (5)
screws from the bottom of the dash trim bezel. Pull out on the upper edge of the bezel and
remove.
2
2-SHAFT HEAD UNITS: Slide the aftermarket head unit into the kit and secure with shaft
nuts. (see Fig. A)
DIN HEAD UNITS: Cut and remove the shaft supports from the Radio Housing. Slide the
DIN cage into the kit and secure by bending the metal locking tabs down. Slide the aftermarket
head unit into the cage until secure. (see Fig. B)
1
3
Using the dimensions above, cut and remove the rear portion of the factory pocket from the
radio trim bezel.
4
Locate the recessed slots on the top of the Faceplate and drill (1) 3/16" hole into each slot.
1½"
3/8"
2