Call Waiting; Switching From The Handset To Base Or Base To Handset; Switching From Handset To Base Unit Speakerphone; Switching From Speakerphone To Handset - VTech VT 2960 User Manual

BASIC OPERATIONS
NOTE: If you use the Speakerphone in
an environment that is not very quiet,
your caller's voice may fade in and out.
Should this occur, press the MUTE key
before your party begins to speak, then
press MUTE again (to turn MUTE off)
when it's your turn to speak.

CALL WAITING

If you receive a CALL WAITING tone
while you are on a call, press the
appropriate LINE/Flash key to switch
from your current call to the new caller.
Press the LINE/Flash key again to
return to the original call.
NOTE: CALL WAITING is a subscription
service from your local telephone service
provider. Contact your provider for
ordering information.
SWITCHING FROM HANDSET TO
BASE OR BASE TO HANDSET
Switching from Handset to Base Unit
Speakerphone
If you are on a call using the Handset,
and want to switch to the Base Unit
S p e a k e r p h o n e f o r h a n d s - f r e e
conversation, do the following:
1. Press HOLD on the Handset.
2. Press the appropriate LINE key on the
Base Unit to resume your conversation.
Switching from Speakerphone to
Handset
If you are on a Speakerphone call, and
want to switch to the Handset:
1. Press HOLD on the Speakerphone.
2. Press the appropriate LINE/Flash key
on the Handset to resume your
conversation.
N O T E : T h e H a n d s e t a n d
Speakerphone can both be on the same
call at the same time.

INTERCOM/PAGE

The Handset and Base Unit can be
used as an INTERCOM when 1) neither
line is active, or 2) all calls are placed
on HOLD.
The INTERCOM feature allows 2-way
conversation between the Handset and
Base Unit. It also serves as a PAGE/
FIND feature. By pressing INT.COM on
the Base Unit, the Handset will ring 5
times, alerting the Handset user, or
allowing you the opportunity to find the
Handset, in the event it is misplaced.
22