Troubleshooting
Problem
The answerng system
does not answer after
the number of rngs
whch I programmed t.
The outgong
announcement s not
clear.
The messages on the
system are very difficult
to hear.
The answerng system
does not record
messages.
The messages on the
answerng system are
ncomplete.
58
Suggeston
•
Make sure the answerng system s on. When the answerng system s on, the red lght on the
ANS ON/OFF key should be lt.
•
If Toll Saver s actvated, the number of rngs changes to two when there are new messages
watng (page 35).
•
If the memory s full or f the answerng system s off, the system wll answer after ten rngs.
•
In some cases, the answerng system wll be affected by the rngng system used by the local
telephone company.
•
When recordng the announcement, make sure you speak n a normal tone of voce about nne
nches from the telephone base.
•
Make sure there is no background noise (television, music, traffic, etc.) when recording.
Press VOL
•
on the telephone base to ncrease the speaker volume.
on the telephone base to ncrease the speaker volume.
•
Make sure the answerng system s on.
•
If the answerng machne memory s full, t wll not record new messages untl some old
messages are deleted.
•
If a caller leaves a very long message, part of t may be lost when the system dsconnects the
call after four mnutes.
•
If the memory on the system becomes full durng a message, the system stops recordng and
dsconnects the call.
•
If the caller's voce s very soft, the system may stop recordng and dsconnect the call.
www.vtechphones.com