VTech LS6191 Quick Start Manual

Quick start guide

LS6191/LS6191-13/LS6191-15/
LS6191-16/LS6191-17
Introduction
This quick start guide provides you with the basic installation
and setup instructions. A limited set of features are described in
abbreviated form.
You may refer to the Abridged user's manual provided in the
product package for installation and operation instructions, or
see the online Complete user's manual at www.vtechphones.com
for complete installation and operation instructions.
Telephone base installation
Install the telephone base as shown below.
Electrical outlet
(not controlled by
a wall switch)
Telephone wall jack
Telephone base
power adapter
A DSL filter (not
included) is required
if you have DSL
high-speed Internet
service.
The DSL filter must
be plugged into the
telephone wall jack.
Telephone line cord
• Use only the power adapter and battery supplied with
this product.
• If you subscribe to telephone service from a cable company
or a VoIP service provider, contact your cable/VoIP service
provider for more information.
Battery installation
Install the battery as shown below.
1. Insert the battery connector
2. Place the battery with the
securely into the socket.
label THIS SIDE UP
up and the wires inside the
battery compartment.
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Battery Pack / Bloc-piles :
(2.4V Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES.
NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Battery Pack / Bloc-piles :
(2.4V Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES.
NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine
3. Slide the battery 4. Place the handset in the
compartment cover towards telephone base to charge.
the center of the handset until
it clicks into place.
BASE
1 2 ANS ON
10:01 AM 12/08 9
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Battery Pack / Bloc-piles :
WARNING / AVERTISSEMENT : (2.4V Ni-MH)
DO NOT BURN OR PUNCTURE BATTERIES.
Made in China / Fabriqué en chine NE PAS INCINÉRER OU PERCER LES PILES.
displays
when charging.
IMPORTANT:
Check for a dial tone by pressing . If you hear a dial tone, the
installation is successful.
If you do not hear a dial tone:
• Make sure the installation procedures described above are
properly done.
• It may be a wiring problem. If you have changed your telephone
service to digital service from a cable company or a VoIP
service provider, the telephone line may need to be rewired to
allow all existing telephone jacks to work. Contact your
cable/VoIP service provider for more information.
Enter the handset menu
1. Press MENU.
2. Press or until the screen displays the desired feature menu.
3. Press SELECT to enter that menu.
• To return to the previous menu, press CANCEL.
• To return to idle mode, press and hold CANCEL.
Set date and time
If you subscribe to caller ID service, the day, month and time are
set automatically with each incoming call. You can also set the
date and time manually.
1. Press MENU.
2. Scroll to Set date/time, then press SELECT.
3. Use the dialing keys (0-9) to enter the month, date and year,
then press SELECT.
4. Use the dialing keys (0-9) to enter the hour and minute.
5. Press or to choose AM or PM, then press SELECT.
Set number of rings
You can choose two, three, four, five or six rings; or toll saver. With
toll saver selected, the answering system answers after two rings
if you have new messages, or after four rings when there are no
new messages. This enables you to check for new messages and
avoid paying long distance charges when calling from out of your
local area.
1. Press MENU.
Scroll to Answering sys, then press SELECT.
2.
3. Scroll to Ans sys setup, then press SELECT.
4. Scroll to # of rings, then press SELECT.
to choose 6, 5, 4, 3, 2 or Toll saver.
5. Press or
6. Press SELECT.
Record your own announcement
You can use the preset announcement to answer calls, or
replace it with your own recorded announcement. It can be
up to 90 seconds in length.
facing
Press MENU.
1.
2. Scroll to Answering sys, then press SELECT twice.
3. The handset announces, "To play, press 2. To record, press 7."
Press 7 to record.
4. The handset announces, "Record after the tone. Press 5 when
you are done." After the tone, speak towards the handset
microphone. Press 5 when done.
Bluetooth setup
To use a Bluetooth enabled cell phone with your LS6191, you
must first pair and connect your Bluetooth cell phone(s) with the
telephone base. All LS6191 handsets can be used to make or
answer calls on the cell line.
Bluetooth wireless technology operates within a short range
(a maximum of approximately 30 feet). When you pair a Bluetooth
cell phone to the telephone base, make sure your Bluetooth cell
phone is close to the telephone base to maintain sufficient signal
strength. For optimal performance, keep your cell phone within
15 feet of the telephone base while using the cell line.
• The pairing process may take up to one minute. If the pairing
process fails, try again.
Pair and connect your first Bluetooth cell phone
Before you begin, make sure you have cellular
i
coverage and your Bluetooth enabled cell phone is not
connected to any other Bluetooth device.
1. Tap on the telephone base. You
hear two beeps. The screen displays
Pairing D1... and the icon flashes.
1
2. Turn on the Bluetooth feature of your
cell phone. Once your cell phone finds
your VTech phone (VTech LS6191),
press the appropriate key on your cell
phone to continue the pairing process.
• Your cell phone may prompt
you to enter the PIN of the
telephone base. The default PIN
of the telephone base is 0000.
3. When the cell phone is connected
to the telephone base, you hear
two beeps. The corresponding
status icon ( 1 or ) displays.
2
If you have trouble pairing your cell phone, it may not
be compatible with your LS6191. Check the Bluetooth
compatibility list at www.vtechphones.com.
• The pairing process may take up to one minute. If the pairing
process fails, try again.
• The steps for the pairing process may vary for different cell
phones. If this happens, follow the prompts on your cell
phone and your LS6191 to complete the pairing process.
Download directory
You can download up to 200 directory entries to your LS6191 via
Bluetooth wireless technology with the handset.
• Place your cell phone next to the telephone base when you
download a cell phone directory to your LS6191.
Make sure the cell phone is paired to your LS6191, on the
•
device list and connected to the base before you download a
cell phone directory.
• For certain cell phones, you may need to press a key on your
cell phone to confirm the directory download.
• For Android and Blackberry cell phones, you may
also download your cell phone directory to your
LS6191 via the VTech Contact Share application.
Go to www.vtechphones.com/apps/contact_
share for application download.
1. Press MENU.
Scroll to Bluetooth and then
2.
press SELECT.
3. Scroll to Download dir
press SELECT.
4. The handset displays Select a
device briefly. Scroll to choose
the desired device, then press
SELECT. The handset displays
D1 selected/D2 selected.
BASE
5. The handset flashes
Downloading... During the
download process, the handset
1
ANS displays the progress.
ON
2
9
10:01 12/08 When the downloading process
AM
completes, the handset
displays Entries added: XXX
briefly and then returns to the
Bluetooth menu.
IMPORTANT!
Refer to the online Complete user's manual for a full set of
installation and operation instructions. For manual download or
customer service, visit our website at www.vtechphones.com or call
1 (800) 595-9511. In Canada, go to www.vtechcanada.com or call
1 (800) 267-7377.
The Bluetooth ® word mark and logos are owned by Bluetooth SIG, Inc. and
any use of such marks by VTech Holdings Limited is under license.
VTech Holdings Limited is a member of Bluetooth SIG, Inc. Other trademarks
and trade names are those of their respective owners.
Copyright © 2012 for VTECH TELECOMMUNICATIONS LTD.
All rights reserved. Printed in China.
Bluetooth
1
ECO
ANS ON
2
and then
Download dir
1
ECO
ANS ON
2
Select a device
1
ECO
2 ANS ON
D1:Cell Phone A
1
ECO
ANS ON
2
D1 selected
1
ECO
2 ANS ON
Downloading...
18
1
ECO
ANS ON
2
Entries added:
118
1
ECO
ANS ON
2
96-008829-040-100