Battery Charging; Telephone Base Layout - VTech DECT 6.0 CS6114 User Manual

Getting started

Battery charging

Once you have installed the battery, the screen indicates the battery
status (see the table below). If necessary, place the handset in the
telephone base to charge the battery. For best performance, keep
the handset in the telephone base when not in use. The battery is fully
charged after 16 hours of continuous charging. See the table on page 25
for battery operating times.
If the screen is blank, you need to charge the handset without interruption
for at least 30 minutes to give the handset enough charge to use the
telephone for a short time. When the battery is low, the handset displays
Low battery along with a flashing
mode, the handset beeps every 50 seconds.
The following table summarizes the battery charge indicators and actions
to take.
Battery indicators
The screen is blank,
or displays Place in
charger and
The screen displays
Low battery and
flashes.
The screen displays
HANDSET 1 and
--:-- --/--.
If you place the handset in the telephone base without plugging in the battery,
the screen displays No battery.

Telephone base layout

Battery status
Battery has very little or
no charge. The handset
flashes. cannot be used.
Battery has enough
charge to be used for a
short time.
Battery is charged.
icon. If you are on a call in low battery
Action
Charge without interruption
(at least 30 minutes).
Charge without interruption
(about 30 minutes).
To keep the battery charged,
place it in the telephone
base when not in use.
IN USE light
On when the handset is in use.
Flashes quickly when there is an
incoming call.
Flashes when another telephone
sharing the same line is in use.
/FIND HANDSET
Press once and then release to page
the handset (page 12).
4