Top And Rear Panels; Top Panel - Vox Valvetronix Amp VT15 Owner's Manual

Top and rear panels

A. Top panel
1. INPUT/PHONES section
2. Amp section
8
In this chapter we're going to take a look at the top and rear panels of your Valvetronix
amp.
1
INPUT jack
This is where you plug in your guitar.
PHONES jack
Use this jack if you want to output directly to a mixer or recording device, or when
you want to use headphones. The signal that is output from this jack is taken from
directly before the Valve Reactor power amp, and the cabinet response of the guitar
amp will be applied to it.
NOTE: If you connect this jack, no sound will be output from the internal
speaker.
Here you can make settings for the amp. The "chicken head" type knobs reflect the
tradition of VOX amplifiers.
[AMP] switch/selector, LED
Here you can select the amp mode.
Each time you press the [AMP] switch, the AMP LED will change color between
green and red, switching between amp banks A and B. Use the [AMP] selector to
choose a model within the selected amp bank.
The operation of the pre-amp, power amp (class A or AB), the response of the tone
controls and their location within the circuit are all switched according to the amp
model you select here, causing each of these to behave as they do in the original amp.
2
4
The illustration shows the VT15.
3 5