Adjusting The Noise Reduction; Saving A Program - Vox Valvetronix Amp VT15 Owner's Manual

8. If you want to use reverb, turn the [REVERB] knob to adjust the reverb mix amount.

Adjusting the noise reduction

Here's how to adjust the way in which noise is suppressed.
1. Press the [BYPASS] switch to make the BYPASS LED light.
2. While holding down the [TAP] switch, turn the [EDIT] knob to adjust the sensitivity
of the noise reduction. Turning the knob toward the right will produce stronger noise
reduction. If the knob is turned all the way to the left, noise reduction will be off and
will have no effect.
3. If you want to use an effect, press the [BYPASS] switch to make the BYPASS LED go dark.

Saving a program

When you've created a sound you like, here's how to save (write) it.
1. Hold down the [BANK] switch for 0.5 seconds or longer. The BANK LED will blink.
2. Press the [BANK] switch to select the save-destination bank.
3. For two seconds or longer, hold down the [CHANNEL] switch of the channel in
which you want to save the sound. The program will be saved in that channel, and
that bank and channel will be selected.
HINT: For details on the effect types, refer to "Explanation of the amps and
effects" (p.18).
NOTE: Noise reduction is specified individually for each program. In Preset mode
or Channel Select mode, the noise reduction setting will be lost if you switch to
a different program or to Manual mode or turn off the power before saving.
NOTE: Depending on the guitar you're using, raising the noise reduction too
high may cause notes to be cut off.
HINT: If you're saving to a channel in the same bank, proceed from step 3.
HINT: If you decide to cancel the Write operation, press [TAP] at this point. The
LED will stop blinking, and you'll return to the previous mode.
NOTE: The program that was previously in that location will be overwritten;
i.e., the program that had been in the channel you selected in step 3 will be lost.
NOTE: The setting of the [BYPASS] screen is not saved in the program.
NOTE: If you're creating your sound in Preset mode or Channel Select mode,
the changes you made will be lost if you switch to another program or to
Manual mode or turn off the power before saving.
15