64
C
8: F
HAPTER
LEXIBLE
Table 5 Interface attributes of 4-port Sync/Async FIC and 8-port Sync/Async FI
Attribute
Services Supported
Panel and Interface LEDs
Interface Cable
I
C
NTERFACE
ARDS
Description
DDN leased
line
Terminal
access
service
The front panel of 4-port FIC is shown as follows:
Figure 5 4-port Sync/Async panel
The meanings of the LEDs on 4-port FIC are given in the following table:
Table 6 4-port FIC LEDs
LINK
ACT
The front panel of 8-port FIC is shown as follows:
Figure 6 8-port FIC front panel
On 8-port FIC, each link corresponds to a LED. ON means the link is connected.
Blinking means data is being transceived.
The FIC uses sync/async serial interface cable with DB28 connector. V.24 (RS232)
DTE cable: DB25 (male) connector at the network end
V.24 (RS232) DCE cable: DB25 (female) connector at the network end
V.35 DTE cable: 34PIN (male) connector at the network end
V.35 DCE cable: 34PIN (female) connector at the network end
OFF means the link is not connected. ON means the link is
connected.
OFF means no data is being transceived. Blinking means data
is being transceived.
Dialup through
Modem
Backup
Async leased line
Dumb terminal
access