HP 5920 Series Installation Manual page 35

Press Ctrl-B to enter Extended Boot menu...5
In full startup mode, you must press Ctrl + B within five seconds to enter the Boot menu. If you perform no
operation or press a key other than Ctrl + B within five seconds, the system automatically starts up and
displays the following information:
Loading the main images...
Starting to get the image flash:/5900_5920-cmw710-system-a2106p01.bin...........
................................................................................
................................................................................
.............Done!
Starting to get the image flash:/5900_5920-cmw710-boot-a2106p01.bin.............
...........................................................Done!
The flash:/5900_5920-cmw710-boot-a2106p01.bin image is
self-decompressing..............................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
...........................................................Done!
System is starting...
Board checking........................LSW252QF
SDRAM fast selftest........................OK!
Flash fast selftest........................OK!
CPLD selftest..............................OK!
Switch chip selftest.......................OK!
PHY selftest...............................OK!
Please check leds....................FINISHED!
User interface aux0 is available.
Press ENTER to get started.
Press Enter at the prompt, and you can configure the switch when the prompt <HP> appears.
NOTE:
For more information about the configuration commands and CLI, see
Configuration Guides
and
HP 5920 & 5900 Switch Series Command References
31
HP 5920 & 5900 Switch Series
.