Reversing The Scraper; Removing The Blade - Toro 79216 Operator's Manual

Reversing the Scraper

Periodically inspect the scraper blade for wear. Reverse
the scraper blade when it becomes worn and before the
working surface contacts the housing.
1. Raise the blade and support the housing off of the
ground.
2. Remove the carriage bolts and locknuts securing the
scraper (Fig. 21).
3. Reverse the scraper and install it with the previously
removed hardware (Fig. 21).
2
1
m–5568
Figure 21
1. Scraper
2. Carriage bolt
3
3. Locknuts
12

Removing the Blade

Note: Retain all parts for installing the snow blade on the
traction unit in the future.
1. Move the lift lever into the lowest position to remove
the blade.
2. Remove the foot plate to access the tractor frame.
3. Remove the shoulder bolt and flange nut (3/8 inch)
attaching the lift rod to the pivot arm of the lift mount
as shown in figure 22.
5
6
7
8
9
1
Figure 22
1. Lift rod
2. Shoulder bolt
3. Flange nut
4. Pivot arm
5. Lift arm
4. Remove the cotter pin (3/4 inch) and washer (3/8 inch)
securing the lift mount to the frame assembly
(Fig. 23).
5. Remove the clevis pin and cotter pin (3/4 inch)
securing the lift rod to the lift arm (Fig. 22).
6. Remove the lift rod from the traction unit.
1
2
4
3
m–7048
6. Clevis pin
7. Cotter pin, (3/4 inch)
8. Yoke
9. Jam nut