Table of Contents
Advertisement
Removing the Mower
Note: Retain all parts for installing the mower on the
traction unit in the future.
1. Park the machine on a level surface and disengage the
blade control (PTO).
2. Move the motion control levers to the brake position,
stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Lower the height-of-cut lever to the lowest position.
4. Remove the hairpin cotter and clevis pin from the
front support rod on each side of the mower (Fig. 2).
m–6431
Figure 2
1. Hairpin cotter and clevis
pin
5. Remove the nuts on support rods in the front and then
remove them by guiding them out of the traction unit
from the back.
6. Remove the hairpin cotter and washer from the
adjusting rod (Fig. 3) on each side of the mower.
2
1
Figure 3
1. Leveling bracket—38 inch
model shown
2
1
2. Support rod
2
3
m–6432
2. Hairpin cotter and washer
3. Adjusting rod
7. Remove the hairpin cotter and washer at the mower
leveling brackets (Fig. 3) on each side of the mower.
8. Slide the brackets off of the mounting pin.
9. Slide the mower rearward and remove the mower belt
from the engine pulley.
10. Slide the mower out from underneath the tractor.
Assembling the Blade
1. Lift and rotate the channel assembly (Fig. 4) so that
the holes align with the lower blade mounts.
2. Slide the rod through the holes and secure it with two
cotter pins (1 inch) (Fig. 4).
4
2
3
Figure 4
1. Channel assembly
2. Rod
3. Cotter pin, 1 inch
3. Bend the ends of the cotter pins to secure the rod.
4
5
3
1
m–3269
4. Lower blade mounts
5. Upper rod
Advertisement
Table of Contents
