Table of Contents
Advertisement
Starting Instructions
Starting the Engine
1. Remove remote control from storage position on back
of battery cover (Fig. 15).
2. Unwind control harness (Fig. 15) from storage hooks
and place remote control on tow vehicle.
1
Figure 15
1. Control box
3. Move the throttle switch to slow (turtle) position.
4. Move the choke lever fully to the right before starting a
cold engine.
Note: A warm or hot engine may not require choking.
5. Turn the ignition key to the start position. When the
engine starts, release the key.
Important
Do not engage the starter for more than 10
seconds at a time. If the engine fails to start, allow a 30
second cool-down period between attempts. Failure to
follow these instructions can burn out the starter motor.
6. After the engine starts, gradually move the choke to the
left. If the engine stalls or hesitates, move the choke
forward again until the engine warms up.
7. Move the throttle switch to desired fast (rabbit)
position.
Stopping the Engine
1. Move the throttle switch to the slow (turtle) position.
2. Turn the ignition key off.
Note: If the engine has been working hard or is hot, let it
idle for a minute before turning the ignition key off. This
helps cool the engine before it is stopped. In an emergency,
the engine may be stopped immediately.
2
2. Control harness
14
Adjusting Discharge Direction
The direction of the discharge opening can be changed
from right to left by moving the switch on the remote
control.
Operating Tips
Warning
Discharged air has considerable force and could
cause injury or loss of footing.
Stay away from the discharge opening when the
machine is operating.
Keep bystanders away from the discharge
opening when the machine is running.
Practice blowing material. it is advisable to blow the
same direction the wind is blowing to prevent material
from blowing back into the cleared area.
Advertisement
Table of Contents
