Advertisement
Step 1 Assemble
handle
Note: The white switch lock
above the ON/OFF switch, aids
in assembly of your cleaner.
Assembly can be continued if the
switch lock is missing. However,
do not remove the switch lock
until assembly is completed.
Align upper handle and lower
handle as shown.
Step 2 Attach cord
1-3
E
With side marked "UP" visible, insert
large rectangular end of cord into
pocket in bottom of handle.
Make sure rectangular end is
pushed down into the handle as far
as possible.
Slide cord protector (E) toward
upper handle.
1-6
Pull cord tight.
Press cord into place at each of the
three notches indicated.
Do not plug cleaner in until
assembly is totally complete.
4
1-2
B
D
Place upper (C) and lower (D) handle parts on a flat surface,
aligning rod sections (B). With hands on sides of parts, push
them together firmly until they "click" and rod sections lock
together.
*Be careful not to press against rod (B) extending from the
lower handle shown in Fig. 1-3. Do not push handle
together with hands on ends of handle parts.
1-4
F
Rotate cord protector (E) on cord
until you see its arrow (F).
Step 3 Attach handle
1-7
K
J
Note location of tapered rails (J) on
bracket (K) and on lower handle.
A
C
1-5
E
With arrow on cord protector (E)
pointing toward arrow on upper
handle (G), press groove (H) in
cord protector into slot (I) in
upper handle.
1-8
K
L
With printed side of bracket (K)
facing up, slide rails on bracket
onto rails (J) on lower handle until
bracket snaps past the lock tab (L).
G
E
I
H
J
Advertisement
