Advertisement
3-6
Install new battery
Remove old battery and connect new one
to proper polarity snaps.
Final filter
(some models)
The final filter assists in the filtration process to return clean air to the room.
3-8
How to clean
Disconnect cleaner from electrical
outlet.
Removing door
To remove this filter when it becomes
dirty, depress door latch and remove
door.
Headlight
What to buy
This cleaner uses a 12 volt, wedge base type 912 bulb, Hoover part No. 27313-101
3-11
A
How to replace
Disconnect cleaner from electrical
outlet.
Removing hood
Using a Phillips head screwdriver,
remove the 4 hood screws (A) and lift off
carpet height control (B).
Lift hood off cleaner base just enough to
access the bulb.
3-7
Reposition holder and door
Place battery in holder. Snap battery
holder back into place.
Replace bag door as for Fig. 2-18.
3-9
Removing filter
Lift out filter (A) and hand wash it in
cold water with mild detergent.
Let filter air dry and reposition it on
the front of the cleaner. Make sure
the white colored side of filter faces
outward.
3-12
A
B
A
Installing bulb and reposition-
ing hood
Pull old bulb straight out of socket.
Push new bulb straight into socket until
locked in place
Excessive force is not required.
Reposition hood, carpet adjustment
control and the 4 screws. Tighten
screws securely.
3-10
A
Reposition door
Place tabs (B) on door into slot in lower
front of cleaner. Close door.
Should you want to replace this filter,
ask for HOOVER part No. 38766017.
B
11
Advertisement
