Advertisement
1-9
M
Pull bracket toward bottom of handle
slightly to make sure bracket is
locked in place.
Make sure hole in bracket aligns
with hole in handle.
Step 4 Attach bag compartment
1-12
Pull bag door latch forward and
remove door. Set bag door aside.
Step 5 Install Embedded Dirt FINDER™ battery
(Some models only)
1-15
Press in at area indicated on battery
holder and remove holder.
1-10
With ON/OFF switch to the front,
place assembled handle down onto
extension on cleaner base.
Rock handle side to side while
pushing down firmly. Extra pushing
effort may be required.
Push bolt into hole (N) on lower front
of handle.
If bolt will not go through hole
easily , check the following:
• the bracket is properly
positioned (Fig. 1-9)
• the handle is pushed down
completely (Fig. 1-10)
1-13
Q
Slide large tab (P) on bottom of bag
housing into slot between the brack-
et (Q) and the lower handle.
1-16
Connect battery to proper polarity
snaps.
1-11
N
Place nut in recessed area (O) at
back of handle. Hold nut in place
while tightening bolt securely with a
screw driver.
Only one nut is needed on this
model. The extra nut is not required
but has been provided for your
convenience.
1-14
P
T
Note round opening and hooks (R)
on back of bag compartment.
Place opening over dirt tube (S) and
align hooks with slots in handle.
Push very firmly at (T) to snap
hooks into handle.
Pull on bag compartment to make
sure it is completely snapped to
handle.
1-17
Place battery in holder.
Snap battery holder back into place.
Continued
O
R
S
5
Advertisement
