Vizio P42HDTV10A Service Manual page 79

Read Command
Writes
Write bursts are initiated with a Write command, as shown in timing figure Write Command on
following: The starting column and bank addresses are provided with the Write command, and
Auto Precharge is either enabled or disabled for that access. If Auto Precharge is enabled, the
row being accessed is precharged at the completion of the burst. For the generic Write
commands used in the following illustrations, Auto Precharge is disabled.
During Write bursts, the first valid data-in element is registered on the first rising edge of DQS
following the write command, and subsequent data elements are registered on successive edges
of DQS. The Low state on DQS between the Write command and the first rising edge is known
as the write preamble; the Low state on DQS following the last data-in element is known as the
write postamble. The time between the Write command and the first corresponding rising edge of
DQS (tDQSS) is specified with a relatively wide range (from 75% to 125% of one clock cycle), so
most of the Write diagrams that follow are drawn for the two extreme cases (i.e. tDQSS(min) and
tDQSS(max)). Timing figure Write Burst (Burst Length = 4) on page 33 shows the two extremes
of tDQSS for a burst of four. Upon completion of a burst, assuming no other commands have
been initiated, the DQs and DQS enters High-Z and any additional input data is ignored.
CONFIDENTIAL – DO NOT COPY Page 8-47
File No. SG-0184