Using Subwoofer Output; Boosting The Subwoofer Level; Using Nonfading Output - Pioneer AVH-P5700DVD Operation Manual

C_A_u_d_io_A_d---=j_u_st_m_e_n_ts _ _
~)
Section
C~ ~).
3 Touch .... or
~
to select a desired level.
Each time you touch .... or
~
selects level in
the following order:
LOW (low)-MID (mid)-HIGH (high)[!J
Using subwoofer output
This unit is equipped with a subwoofer output
which can be turned on or off,
• When the subwoofer output is on, you can
adj ust the cut-off frequency and the output
level of the subwoofer.
1 Touch SUB WOOFER on the audio func-
tion menu.
• When the subwoofer controller setting is
FULL, you cannot select SUB WOOFER.
2 Touch .... to turn subwoofer output on.
• To turn subwoofer output off, touch
~,
3 Touch T and then touch .... or
~
to se-
lect the phase of subwoofer output.
Touch
~
to select normal phase and
NORMAL appears in the display. Touch .... to
select reverse phase and REVERSE appears in
the display,
4 Touch T and then touch .... or
~
to ad-
just the output level of the subwoofer.
Each time you touch .... or
~
increases or de-
creases the level of the subwoofer.
+6 -
-6 is
displayed as the level is increased or de-
creased,
5 Touch T and then touch .... or
~
to se-
lect cut-off frequency.
Each time you touch .... or
~
selects cut-off fre-
quencies in the following order:
SOHz-80Hz--125Hz
Only frequencies lower than those in the se-
lected range are outputted from the sub-
woofer, [!J
Boosting the subwoofer level
You can easily boost the subwoofer bass level
by repeatedly pressing BOOST button. If the
subwoofer is set to OFF, pressing BOOST but-
ton automatically sets the subwoofer to ON.
• Press BOOST button to increase the
subwoofer level.
The subwoofer level
0-+6
is shown in the dis-
play,
• To decrease the level, press BOOST button
and hold. The subwoofer level is reset to 0 and
then you can start again,
• Note
You can also select the subwoofer level in the
auido menu. Refer to Using subwoofer output on
this page.[!J
Using nonfading output
When the nonfading output setting is on, the
audio signal does not pass through this unit's
low pass filter (for the subwoofer), but is out-
putted through the RCA output.
1 Touch NON FADING on the audio func-
tion menu.
• When the subwoofer controller setting is only
FULL. you can select NON FADING. (Referto
page 89,)
2
Touch. to turn non fading output on.
• To turn non fading output off, touch T.
3 Touch .... or
~
to adjust the output level
of the non fading.
Each time you touch .... or
~
increases or de-
creases the level of the non fading.
+6 - -6
is
displayed as the level is increased or
decreased. [!J
En
GD