Monitoring The System; Recovering The Unit - Bosch DIVAR IP all-in-one 7000 3U Installation Manual

46 en | Maintenance
To replace the power distributor:
1.
2.
3.
4.
5.
6.
7.
9.16

Monitoring the system

The system provides tools for health monitoring.
To activate the monitoring functionality, you have to logon to the administrator account
(BVRAdmin).
1.
2.
3.
4.
5.
6.
7.
8.
9.
9.17

Recovering the unit

Following procedure describes how to restore the factory default image.
To restore the unit to factory default image:
1.
2.
2020.04 | V1.1 | DOC
Turn off the unit and remove the plug from the wall socket or power strip.
Remove all cable connections to the power supply from the motherboard, backplane, and
other components. Also, remove both power supplies.
Locate the power distributor between the power supply and the fan row.
Remove the three screws securing the power supply.
Gently pull the power distributor from the chassis. Gently guide all the cables through the
power distributor housing.
Slide the new power distributor module into the power distributor housing. Make that
you slide the cables through the bottom of the housing.
Reconnect all the power cables, replace the power supply, and insert the plug into the
wall.
On the BVMS default screen, press CTRL+ALT+DEL.
Hold SHIFT, click Switch User and keep SHIFT pressed for about five seconds.
Enter user name and password.
On the Desktop, in the Tools folder, right-click the Enable_SuperDoctor_5_Service script,
and then click Run as administrator.
Double-click the SuperDoctor 5 Web icon in the same folder.
Log on to the web interface using the following default credentials:
User Name: ADMIN
Password: ADMIN
Click the Configuration tab, and then click Password Settings and change the default
password.
Click the Configuration tab, and then click Alert Configuration.
Activate the SNMP Trap feature and specify the IP address of the receiver for SNMP
traps.
Start the unit and press F7 during the BIOS power-on-self-test.
The Recovery menu is displayed.
Select one of the following:
– Initial factory setup: restores to factory default image and deletes all data on the
HDDs.
or
– System Recovery (back to Factory Defaults): restores to factory default image; data
on the HDDs will not be deleted.
Note:
While the System Recovery option doesn't delete video footage stored on the data HDDs,
it still replaces the complete OS partition (including VMS settings) with a default
configuration. In order to access existing video footage after recovery, the VMS
configuration needs to be exported before System Recovery and re-imported afterwards.
Installation manual
DIVAR IP all-in-one 7000 (3U)
Bosch Security Systems B.V.