Installing A Hard Drive Carrier Into A Rear Hard Drive Bay; Replacing The Dvd Rom Drive; Replacing The Front Port Panel - Bosch DIVAR IP all-in-one 7000 3U Installation Manual

40 en | Maintenance
9.6.3

Installing a hard drive carrier into a rear hard drive bay

To install a hard drive carrier into a hard drive bay:
1.
2.
9.7

Replacing the DVD ROM drive

The unit includes a DVD-ROM which is pre-installed.
To replace the DVD-ROM drive:
1.
2.
3.
4.
5.
6.
7.
9.8

Replacing the front port panel

To replace the front port panel:
1.
2.
3.
2020.04 | V1.1 | DOC
Insert the hard drive carrier horizontally into the hard drive bay, orienting the hard drive
carrier so that the release button is on the right.
Push the hard drive carrier into the bay until the handle retracts and the hard drive clicks
into the locked position.
1
1 DVD-ROM
Turn off the unit and if necessary, remove the unit from the rack.
Remove the chassis cover.
Unplug the drives power and data cables from the motherboard and/or backplane.
Locate the locking tab at the rear (on the left when viewed from front) of the DVD-ROM
drive. Push the tab toward the drive and push the drive unit out the front of the chassis.
Insert the new drive unit in the slot until the tab locks in place.
Reconnect the data and power cables.
Replace the chassis cover. replace the unit in the rack, if necessary, then turn on the
system.
Turn off and unplug the unit.
Remove the chassis cover.
Disconnect the power and data cables from the front port panel to other chassis
components including the motherboard and backplane.
2
Installation manual
DIVAR IP all-in-one 7000 (3U)
2
Front port panel
Bosch Security Systems B.V.