Setup Menu; Format; Beep; Power Off - Vivitar Vivicam 3715 User Manual

Setup menu

You can select your preferences for the camera settings in SET-UP mode. Turn the
mode dial to SET-UP mode and navigate to the option you wish to configure by
using the

Format

This option formats the internal memory (or
memory card) and erases all stored images and
data. To perform the format function, first press
the button. Then select [Yes] by using the
button and press OK. A progress bar
displays, showing the progress of formatting.

Beep

E
The camera makes a sound (beep) each time
you press the camera button if this function is
enabled. Press the
by using the

Power off

If the camera goes unused for a certain period
of time while the camera is powered on, the
camera will switch to an idle mode, and eventu-
ally turn itself off to conserve power.
Inactivity period
(batteries)
60 seconds
30 minutes
If the camera is idle, re-activate the camera by pressing any button or switch the
mode dial. If the camera has powered-off you must turn the camera on again by
pressing the
and power-off. To change the power saving interval, first press the
select the power-off interval you perfer by using the
[3 min], [5 min], [10 min], [30 min]
42
/ button.
button. Select [On] or [Off]
/ button and then press OK.
Inactivity period
(AC power adapter)
button. The table (above) shows the default time settings for idle,
/
60 seconds
30 minutes
Camera status
stay idle
shut off
button. Then
/ button and press OK.