Lincoln Electric POWERTEC 205C Series Operator's Manual page 14

Transport & Lifting
Falling equipment can cause injury and
damage to unit.
To safety transport and lift POWERTEC 205C (see the
Figure 20):

Does not include the eye bolt which can be used to
transport or lifting the machine.

Use equipment of adequate capacity to lift and
support unit. Use a travers and minimum two belts as
is shown of Figure 20.

Lift only power source without gas cylinder, cooler
and wire feeder, or/and any other accessories.

Apply load axially in 45 degree angle in accordance
to the Figure 20.

Ensure equal length of lifting lines.

Do not use handle to lift or support unit
Figure 20.
To safety transport and lift POWERTEC 255C & 305C
(see the Figure 21):

Use equipment of adequate capacity to lift and
support unit.

Always lift and support unit using both eye bolts.

Do not use one eye bolt to lift or support unit.

Lift only power source without gas cylinder , cooler
and wire feeder, or any other accessories.

Screw down an eye bolt and apply load axially in 45
degree angle in accordance to the Figure 21.

Ensure equal length of lifting lines.

Do not use handle to lift or support unit.
English
WARNING
11
Figure 21.
English