Plugging In A Usb Storage Device; Unplugging A Usb Storage Device; Connecting And Disconnecting An Ipod; Connecting Your Ipod - Pioneer MZ360500EX Owner's Manual

Navigation av system
Table of Contents

Advertisement

Basic operation
This navigation system may not achieve
optimum performance with some USB
storage devices.
Connection via a USB hub is not possible.

Plugging in a USB storage device

1. Pull out the plug from the USB port of the
USB interface cable for iPod.
2. Plug a USB storage device into the USB
interface cable.
USB interface cable

Unplugging a USB storage device

* Pull out the USB storage device after
checking that no data is being accessed.
Connecting and
disconnecting an iPod
! CAUTION
• To prevent data loss and damage to the
storage device, never remove it from this
navigation system while data is being
transferred.
• Pioneer cannot guarantee compatibility
with all USB mass storage devices and
assumes no responsibility for any loss of
data on media players, iPhone,
smartphone, or other devices while using
this product.

Connecting your iPod

Using the USB interface cable for iPod
enables you to connect your iPod to the
navigation system.
A USB interface cable for iPod (sold
separately) is required for connection.
For details about iPod compatibility with
this navigation system, refer to the
information on our website.
Connection via a USB hub is not possible.
24
USB storage device
1. Check that no USB storage device is
connected.
2. Connect your iPod.
USB interface cable
Mini-jack connector

Disconnecting your iPod

* Pull out the USB interface cable for iPod
after checking that no data is being
accessed.

Startup and termination

1. Start the engine.
2. Press the HOME button to boot up the
system.
After a short pause, the splash screen comes
on for a few seconds.
To protect the LCD screen from damage,
be sure to touch the touch panel keys only
with your finger and do so gently.
3. Turn off the vehicle engine to terminate
the system.
The navigation system is also turned off.

On first-time startup

When you use the navigation function for the
first time, an initial setup process starts
automatically. Follow the steps below.
1. Start the engine.
2. Press the HOME button to boot up the
system.
After a short pause, the splash screen comes
on for a few seconds.
USB interface cable for iPod

Advertisement

Table of Contents
loading

Table of Contents