Cisco Catalyst 9117AX Series Getting Started Manual page 6

Cisco Catalyst 9117AX Series Access Points
3
Safety Instructions
Translated versions of the following safety warnings are provided in the translated safety warnings document that is
shipped with your access point. The translated warnings are also in the Translated Safety Warnings for Cisco Catalyst
Access Points, which is available on Cisco.com.
Warning IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with
standard practices for preventing accidents. Use the statement number provided at the end of each
warning to locate its translation in the translated safety warnings that accompanied this device.
SAVE THESE INSTRUCTIONS Statement 1071
Warning Read the installation instructions before using, installing or connecting the system to the power source.
Statement 1004
Warning Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning Do not operate your wireless network device near unshielded blasting caps or in an explosive
environment unless the device has been modified to be especially qualified for such use. Statement 245B
Warning In order to comply with FCC radio frequency (RF) exposure limits, antennas should be located at a
minimum of 12 inches (30 cm) or more from the body of all persons. Statement 332
The fasteners you use to mount an access point on a ceiling must be capable of maintaining a minimum
Caution
pullout force of 20 lbs (9 kg) and must use all 4 indented holes on the mounting bracket.
This product and all interconnected equipment must be installed indoors within the same building,
Caution
including the associated LAN connections as defined by Environment A of the IEEE 802.af Standard.
Warning This equipment is suitable for use in environment air spaces (plenums) in accordance with Section
300.22 (C) of the National Electrical Code, and Sections 2-128, 12-010(3) and 12-100 of the Canadian
Electrical Code, Part 1, CSA C22.2. External power supply, power adapter and/or power injector, if
provided, are not suitable for installation in air spaces. Statement 440
Warning Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
6