Table of Contents
Advertisement
18
V
9650 S
ISIONEER
U
'
G
CANNER
SER
S
UIDE
Note: If you have not installed the scanner driver, unplug the USB
cable from the computer and install the software now. When the
driver installation is complete, a message tells you when to connect
the scanner.
3. Turn on the power switch, located on the back of the scanner.
The status light comes on and flashes indicating that the scanner is
receiving power.
If you are using Windows XP Service Pack 2, and have plugged the
USB cable into a USB 1.1 port, an information bubble may open
explaining that "A HI-SPEED USB device is plugged into a non-
HI-SPEED USB hub". Plug the USB cable into a USB 2.0 port (if
available) or just disregard the message. If you leave it plugged into
the USB 1.1 port, your scanner may scan a bit slower.
Advertisement
Table of Contents
Troubleshooting
