Whirlpool CAM2752 Installation Instructions Manual page 31

ELECTRONICCONTROL SETUP INSTRUCTIONS
If cycle counter (90C) is selected, the following is true:
1 00 Cycles in HUNDREDS 1 0__22 = 200
2 00 Cycles in ONES 2 2__5 = 25
TOTAL CYCLES= 225
This is "VIEW ONLY" and cannot be cleared.
• Press the PERM PRESSbutton once to advance to next code.
If money counter (I.0C or I.C0) is selected, the following is
true:
300 Dollars in HUNDREDS 30:1 = _;100.00
400 Dollars in ONES 46__8_8 = $ 68.00
500 Number of CENTS 57__55 = ._ 00.75
TOTAL = ._168.75
END of SET-UP PROCEDURES
TO EXIT FROM SET-UP MODE
1. Close the service access door.
2. Disconnect dryer from power before reinstalling the AA1
connector, if it was removed.
3. Remove the manual set-up card.
Diagnostic Codes
If the set-up mode is entered and one of the following has
previously occurred, the appropriate diagnostic code will be
in the display.
d5
Blocked coin 1 or coin drop UI control
circuit failure (coin recognition and
customer display disabled while
blockage persists).
d 9 Voltage detected below 90 VAC for
8 seconds.
d 13 Blocked coin 2 or coin drop UI control
circuit failure (coin recognition and
customer display disabled while
blockage persists).
d 16 Not receiving communications
from installed debit card reader in
Enhanced (Generation 2) Debit mode.
F 01
F 22
F 23
F 70
F71
F 73
F 74
Dryer motor control circuit error
(cycles and price display disabled until
diagnostic code is manually cleared).
The control doesn't know if the motor
relay is bad (stuck on), the motor relay
drive circuit is bad (shorted), causing
the motor relay to stay on, or the
motor relay feedback circuit is bad.
Exhaust thermistor open, temperature
drops below 18°F (>50 kO) for 1
minute in Run mode, or immediately
in Factory Diagnostic Mode.
Exhaust thermistor shorted,
temperature above 250°F (<500Q) for
i minute in Run mode, or immediately
in Factory Diagnostic Mode.
UI is not receiving communications
from CCU (cycles and price display
disabled while error persists or is
manually cleared).
CCU is not receiving communications
from UI (cycles and price display
disabled while error persists or is
manually cleared).
UI Microprocessor is not able to read
or verify EEPROM (cycles and price
display disabled until diagnostic code
is manually cleared).
UI EEPROM memory is a CRC failure
(cycles and price display disabled until
diagnostic code is manually cleared).
31